Kavenz VHP16 MX

Edit 10/18/2023
The rear stay can be customized via "Seat Stay V7 - (Trade-In Upgrade)", see 77-Store. The rear stay thus becomes UDHready and the rear stay length is adjustable in steps +0 +10 +20.

I offer my February 2021 (Batch1) purchased frame without shock with Reset Racing headset for sale.
Color Alu Raw with black anodized chainstays

Size M
Reach 460mm
Head tube 110mm
Seat tube 420mm

Full description on the manufacturer's site see image "Detail Links".

The frame can be driven with 27.5" or 29" rear wheel.
The 27er shockmount is installed. The wheel can be built so also with the 29er wheel, so the steering angle and seat angle will be a little steeper, a little more ground clearance and reach. To preserve the original geometry, you can buy and install the 29er Shockmount, see picture "Detail Links".

The frame is crash-free, so no dents or nicks. just the usual signs of wear see detail pictures.

The wheel in the complete setup was in use until mid-September 2023.
I clean the wheel very rarely and if only via bucket and washing brush, no pressure washer. The wheel is stored when not in use all year round at constant moderate temperatures in the boiler room, the bearings are therefore still in good condition.

The Acrossteuersatz installed in the original was replaced in mid-2022 by a Reset Racing Flatstack.

The chainline of the Idler is 52mm can be adjusted via accessories see picture "Detail Left".

The idler itself has only a few months of operation behind it, bearings + tooth profile still have at least 1 year remaining life.


In addition to the frame small parts for the body, the headset is also included. See photo "small parts

1. (1.)Homemade down tube guard made from 3mm ABS
2. (2.)Axle wrench
3. (3.)Replacement derailleur hanger (i.e., a second one to the one built into the frame)
4. (4.)unused accessories to the headset (have used identical headset in the new frame with the "old" parts)
Fork cone, centering ring, cover and fork cone
5. (5.)Chainguide adapter for the frame
6. (6.)Seatpost clamp from 77desings
7. (7.)Rear brake adapter including screws for frame mounting
.
8. (8.)Rattletube for brake line (the other two are with the cables still in the frame)
9. (9.)Space Chaineguide to fit the chainline
10. (10.)Unused brake line guide parts for downtube and chainstay exit

General notice.
Sale is by me as a private person.I exclude any liability for material defects.
This sale takes place under exclusion of any warranty.
The condition I describe to the best of my knowledge and belief.For me obvious defects, limitations of function or the like I mention of course.